WGR614v9 Initial Release Firmware - Version 1.0.9
and Version 1.0.13 for Russia

Published December 06, 2007.

Installation Instructions:

1. Download the file to a convenient place such as your desktop.

   For use inside North America Only

   1.81 MB

   Version 1.0.13 for users in Russia

   1.82 MB

   Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.

   For users outside North America & Russia

   1.81 MB

2. Open a Web browser.
3. Access the router (http://192.168.1.1 or the Default Gateway address if the router's default IP was changed).
4. Log in the router (User Name = admin and Password = password, unless you changed it).
5. Write down all settings that you entered when previously configuring. (Usually this includes information such as ISP configuration and wireless security settings.)
6. Under Maintenance, click Router Upgrade.
7. Click Browse and locate the firmware upgrade file.
8. Click Upload.
9. Wait for the router to reboot.
10. Under Maintenance, click Settings Backup, then click Erase. (Or press the reset button on the back for 10 seconds.)
11. Wait one minute for the router to reboot.
12. Manually enter the configuration information you wrote down in Step 4.

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page. The GPL Code and LGPL Code used in this product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and LGPL Code for this product and the terms of the GPL and LGPL.

d103224..asp