|
WNR854T RangeMax Next Router
Firmware Version 1.1.26
For Use Outside North America
Published July 24, 2006
- Do not turn the DMZ feature on in this release!
- Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.
Fixes
- ISP BigPond dial-on-demand now works.
Known Issues
- Router GUI does not support Netscape, Firefox or Safari browsers.
- Light status is not corrrect in various situations.
- Port triggering does not work under certain situations.
- Block Site allows only up to 10 entries.
- Block Site does not always work with some strings.
- Multiple port forwarding entries with the same port number, but differing IPs can be added.
- WEP, WPA and WPA2 do not work under certain situations.
- Log messages are not generated for blocked services or remote management.
- UPnP settings cannot be changed.
- MTU handling does not work.
- Remote management does not work.
To Install
Note: Do not upgrade the firmware using a wireless connection. Please perform firmware upgrade with “wired” or Ethernet connection only.
- Write down all the settings which you changed from the default values, since you may need to reenter them manually.
- Download using the button below to a convenient
place such as your desktop.
 6.00 MB
- Log in to the router using a Web broswer. The URL is http://192.168.1.1 ( if you did not change the router’s IP address ).
- Click Maintenance > Router Upgrade
- Click Browse and find the file you just downloaded.
- Click Upload. Do not interrupt the upgrade while the router does this step.
The router reboots when the upgrade is done.
- After the router boots up, log in the router again.
- Click Maintenance > Backup Settings
- Click Erase. The router reboots when the Erase operation is done.
- If you would like to check that the upgrade was successful, log in to the router again at http://192.168.1.1, and check the firmware version.
- Re-configure the router with the settings you saved in step 1. Optionally, You can use the Smart Wizard configuration assistant on the CD to reconfigure the router.
Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate.
This product includes software code developed by third parties,
including software code subject to the GNU General Public License ("GPL")
or GNU Lesser General Public License ("LGPL"). As applicable, the
terms of the GPL and LGPL, and information on obtaining access to the GPL Code
and LGPL Code used in this product, are available to you at NETGEAR's
Open Source Code Web page. The GPL Code and LGPL Code used in this
product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights
of one or more authors. For details, see the GPL Code and LGPL Code for this
product and the terms of the GPL and LGPL.
D102892.asp
|
|
|
