WGR614v1 Firmware Version 1126

Published Sept. 30, 2003

Enhancements

Added Packet Burst Mode. Packet burst mode enable is available through the "Wireless" setting menu. The "Packet burst" option was optimized to the specific type of network through the wireless "mode" pull down menu (b only, b and g, g only). Due to packet bursting, a boost in the wireless performance is only possible if the transmitting unit has enabled "burst mode". The greatest performance improvement is in mixed b and g mode wireless networks.

Bug Fixes

• Fixed missing regulatory domains
• Fixed hidden SSIDs incorrectly implemented
• Fix IBSS probe response doesn't convey correct beacon period
• Fix client using AUTH_BOTH mode results in intermediate failure to authenticate with some AP
• Fix timestamp in IBSS beacons not always sync'd
• Fix roaming from some AP causes client to associate to ANY
• Fix that could not connect to a AP with a space as its SSID

Enhancements from Version 1123

1. 802.11g compliant
2. Added Block Broadcast SSID support

Bug fixes from Version 1123

1. Fixed default MTU values for DHCP, PPPoE, and PPTP
2. Fixed minor HTML errors on the setup and configuration pages

Upgrading to the New Software

You can upgrade by using the web interface Router Upgrade menu

1. Before you upgrade write down all of your current settings as you will need to enter them in MANUALLY after upgrading your firmware
2. Open the browser and access the router (usually the address is http://192.168.0.1)
3. Login to the router (User Name = admin Password = password unless you have changed it)
4. Click Maintenance > Router Upgrade
5. Click Browse and locate the upgrade file (download link is below)
6. Click Upload
7. Wait for the router to reboot
8. Verify that the router firmware has been upgraded
9. Reset router to factory defaults
10. Wait for the router to reboot
11. Re-enter the settings you noted down before upgrading

702KB

D102135.asp