WG102 Firmware Version 4.0.27
North America (N.A.) & World Wide (W.W.) releases

Published Mar 31, 2008

New Features:

1. Allow 8 IP subnets to access and configure the AP. By default, any IP Address can access and configure the AP through WEB. But, if you turn the WEB access control ON, only IP addresses that are in the trusted IP subnets can access the AP.
2. Change HTTP Redirect function. Now, user will only be redirected when first accessing the internet.
3. Add SNMP support for the following private MIB objects: total memory, free available memory, system runtime, and 802.1x authenticated wireless station number.

Bug Fixes:

1. Fixed the issue that 802.1x Authentication does not work with machine authentication.
2. Fixed the bug that user can access the WEB page without entering the password after logging out using Mozilla Firefox.
3. Fixed the problem that no error checking is done for the Access Point name. Now, only numbers 0-9, the letters A-Z and a-z can be entered.
4. Fixed the bug that after disabling the radio, the wireless LED still blinks.

Known Limitations

1. The access point needs to be rebooted after configuration changes.
2. Only tagged VLAN are supported.
3. Turn Access Control On checkbox gets cleared automatically after adding a trusted MAC Address to the Access Control List.

To Upgrade

Warning:

• Do NOT interrupt the upgrade process until it is done.
• Device will enter TFTP mode, if you press and hold the rear reset button for over 15 seconds. To exit the TFTP mode, please power cycle the devic

1. Choose the correct download for your country. Download the link below and save it to a convenient place such as your desktop.
   

   Download for North America (N.A.)

1.23 MB

Download for use only outside North America (W.W.)

1.23 MB

1. Log in the WG102 access point.
2. Search the Management section, and click the Upgrade Firmware.
3. Click Browse and select the firmware image (.img) file from the folder where you downloaded the file.
4. Click Upgrade to start upgrading. This takes several minutes.
   Do NOT interrupt the upgrade process until it is done.
5. The access point will automatically reboot after the firmware upgrade process is complete.

MIB File for SNMP Monitoring (optional download): download here

D103275.asp