WG102 Firmware Version 4.0.16
North America (N.A.) & World Wide (W.W.) releases

Published Sep 13, 2007

Bug Fixes:

1. Fixed the issue that DNS setting, Admin password, and Security Key cannot be restored from a saved configuration file.
2. Fixed the bug that HTTP-redirect function does not work with Mozilla Firefox.
3. Fixed the instability issue when client roams from one WG102 to another.

Known Limitations

1. The access point needs to be rebooted after configuration changes.
2. Only tagged VLAN are supported.
3. Turn Access Control On checkbox gets cleared automatically after adding a trusted MAC Address to the Access Control List.

To Upgrade

Warning:

• Do NOT interrupt the upgrade process until it is done.
• Device will enter TFTP mode, if you press and hold the rear reset button for over 15 seconds. To exit the TFTP mode, please power cycle the devic

1. Choose the correct download for your country. Download the link below and save it to a convenient place such as your desktop.
   Extract/Unzip the downloaded file to a new folder.

   Download for North America (N.A.)

1.21 MB

Download for use only outside North America (W.W.)

1.21 MB

1. Log in the WG102 access point.
2. Search the Management section, and click the Upgrade Firmware.
3. Click Browse and select the firmware image (.img) file from the folder where you extracted the downloaded file.
4. Click Upgrade to start upgrading. This takes several minutes.
   Do NOT interrupt the upgrade process until it is done.
5. The access point will automatically reboot after the firmware upgrade process is complete.

MIB File for SNMP Monitoring (optional download): download here

D103179.asp