WG102 Firmware Version 4.0.12
North America (N.A.) & World Wide (W.W.) releases

Published Feb 15, 2007

New Features and Enhancements:

1. Enhanced SNMP Features - Three new SNMP MIB object (wlanStationCount, ethWrongPackets, and wlanWrongPacket) are added.
2. Added a new function to allow user to configure the port number for SNMP trap. The default is 162.

Known Limitations

1. The access point needs to be rebooted after configuration changes.
2. Only tagged VLAN are supported.

To Upgrade

Warning:

• Do NOT interrupt the upgrade process until it is done.
• Device will enter TFTP mode, if you press and hold the rear reset button for over 15 seconds. To exit the TFTP mode, please power cycle the devic

1. Choose the correct download for your country. Download the link below and save it to a convenient place such as your desktop.
   Extract/Unzip the downloaded file to a new folder.

   Download for North America (N.A.)

1.22 MB

Download for use only outside North America (W.W.)

1.22 MB

1. Log in the WG102 access point.
2. Search the Management section, and click the Upgrade Firmware.
3. Click Browse and select the firmware image (.img) file from the folder where you extracted the downloaded file.
4. Click Upgrade to start upgrading. This takes several minutes.
   Do NOT interrupt the upgrade process until it is done.
5. The access point will automatically reboot after the firmware upgrade process is complete.

D103058.asp